All data available are in GCS datum EPSG:4326 WGS84 CRS (Coordinate Reference System).You can download these data in KML, GeoJSON, CSV or Shapefile formats. You can use these data for analysis in IGISMAP itself or download them in any suitable GIS format. Here you can download the GIS data of the state boundary, county division, rail and highway maps in just a few clicks. NW corner of the NW corner, Section 22, T.2S., R.2E.GIS Data and Maps of Wyoming State is used by planners and surveyors for visualizing and identifying the patterns that are difficult to examine when data is in table form.
In the case below, the section location is written as T.2S., R.2E., M.D.M., which describes Township 2 South, Range 2Įxample 1 - What is the township, range, and section of the lightning strike labeled "X" in the figure?Įxample 2 - What would you tell the dispatcher is the exact location of the lightning strike using corners? The legal description of land begins with the smallest unit and ends with the largest unit. The lightning strike is located in the northwest corner of the northwest corner of section 22 of T.2S., R.2E. For example, the figure below indicates a lightning strike at the point labeled "X" in section 22. Corners can be described as northeast, southeast, northwest, and southwest. Any township can be found by identifying the township number, then the range number, and finally the base and meridian system.Ĭorners describe areas within a section to provide more specific location information. The section below is taken from T.2S., R.2E. Sections are numbered from the top right, or northeast section, then to the left, and down in an "S" formation. A township can be divided into 36 sections. Sections represent further divisions of a township.
They are numbered starting at the meridian that runs through the point of origin of each system. Ranges are columns of townships set side by side. The squares are gridded and numbered according to their position north or south of the base line. Townships are rectangular blocks of land about 6 miles square. Use geographic locations, such as prominent features of the area, as reference points. Base and meridian lines are similar to latitude and longitude lines.
0 kommentar(er)
